User Manual Q&AAnswer
Mar 04, 2025 - 01:58 AM
To install the CALIBER CAM 030 camera, follow these steps:
1. Choose a suitable location for the camera that will provide the best view behind the vehicle. Avoid placing it directly next to or under a reverse backup lamp or license plate lamp, as they may blind the camera at night.
2. Determine which casing option (A/B/C) is most suitable for your vehicle.
3. Wire the camera's power wire to the vehicle's reverse lamp:
a) Locate the reverse lamp in the tail light assembly.
b) Using a crimp connector or by soldering, attach the red wire from the camera to the positive 12-volt wire from the reverse lamp. This wire should only have power when the car is in reverse gear and the white lamp is illuminated. Attach the black wire to the ground (negative 12 volts).
4. Run the extension cable to the location of the monitor/head-unit (not included) and connect the other end of the extension cable to the camera. The yellow RCA connector should be connected to the Video/CAM input.
5. Optional wiring:
- Blue wire: Cut this wire to turn off the guiding lines displayed on the screen.
- White wire: Cut this wire to horizontally mirror the image on the screen. Turn the camera off and on again for the change to take effect.
6. Head-unit connection:
- On some head-units, you may need to connect the 12V red wire from the camera to the 'back cam wire' on your head-unit. This will automatically turn on the screen when reversing.
7. Choose the appropriate mounting casing option:
- Option A) Built-in mounting casing: Drill a 25mm hole in a suitable location on the rear bumper and insert the camera.
- Option B) Built-on mounting casing: Mount the camera above the number plate on the rear of the vehicle.
- Option C) Built-on mounting casing: Mount the camera in a suitable location above the number plate on the rear of the vehicle.
Please refer to the CALIBER CAM 030 User Manual for more detailed instructions and illustrations.
Add New Comment