How do I install the AUDIBAX Flint Kit? (AUDIBAX Flint Kit User Manual)

Answer

manuals.plus

Mar 04, 2025 - 01:52 AM


To install the AUDIBAX Flint Kit, please follow the instructions provided in the user manual. Here is a step-by-step guide:

1. Exposed Installation of Bottom Box:
- Ensure that the bottom box depth is not less than 40mm.
- Drill holes in the wall according to the  xxxx  holes at the four corners of the bottom surface of the box.
- Thread the line end through the reserved holes around the box.
- Securely fix the box on the wall with 4 self-tapping screws.

2. Disassembly:
- Find the gap between the right side of the front panel of the amplifier and the base.
- Use a slotted screwdriver to carefully pry the buckle part of the gap.
- Hold the front panel of the amplifier with both hands and separate it from the base as parallelly as possible.
- Select the two clips in the direction of A or B, push the outer edge outward to loosen the clips, and separate the front panel of the amplifier and the base.
- Connect the line end to the port on the base of the amplifier and fix the base on the two mounting columns with two screws.
- Align the front panel of the amplifier with the fixed base, close and fasten them, and check the stability.

3. Digital Amplifier Installation:
- Concealed Installation of Bottom Box:
  - Open a groove suitable for the box dimension on the wall.
  - Drill holes in the groove according to the  xxxx  holes at the four corners of the bottom surface of the box.
  - Thread the line end through the reserved holes around the box.
  - Put the box into the wall groove and fix it securely with 4 self-tapping screws.

4. Digital Amplifier Connection:
- Connect the power input (~100-240V), FM antenna, signal ground, audio input, audio output, and amplifier output ports according to the provided diagram.
- Ensure all wire connectors are properly connected and not exposed.

5. Ceiling Speaker Installation:
- Select the hole size of the corresponding model and open the installation hole in the desired position.
- Connect the audio signal cable to the speaker.
- Push up the spring clamps on both sides of the speaker and keep them in this state.
- Carefully push the speaker into the open mounting hole and release the spring clamps to secure the speaker in the ceiling.

Please refer to the user manual for more detailed instructions and illustrations.