Answer

Mar 04, 2025 - 01:50 AM
To connect the ENS Security HNC3I189T1-ZASPV 4MP Bullet Network Camera to your network, please follow the steps below:
1. Locate the Ethernet port on the camera (port number 2 in Table 1-1).
2. Connect one end of a network cable to the Ethernet port on the camera.
3. Connect the other end of the network cable to your network router or switch.
4. If your network router or switch supports Power over Ethernet (PoE), the camera will be powered through the network cable. If not, you will need to connect a separate 12VDC power supply to the camera's power input port (port number 1 in Table 1-1).
5. Once the camera is connected to the network and powered on, you can access its settings and view the camera feed through a web browser by entering the camera's IP address in the address bar. The default IP address is 192.168.1.108. You may need to install a plugin for your browser to access the camera's web interface.
Please refer to the "Network Configuration" section in the user manual for more detailed instructions and information on configuring the camera's network settings.
Add New Comment