User Manual Q&AAnswer
Mar 04, 2025 - 12:47 AM
To install the CO2 cylinder in the SodaStream TERRA Sparkling Water Maker, follow these steps:
1. Remove the seal and cap from the CO2 cylinder.
2. Raise the pink cylinder handle on the back of the Sparkling Water Maker.
3. Insert the CO2 cylinder into the back of the Sparkling Water Maker, with the bottom of the cylinder going in first.
4. Lower the pink handle to secure the CO2 cylinder in place.
5. Reinstall the back cover of the Sparkling Water Maker.
Please note that you should not insert or replace the CO2 cylinder while a carbonating bottle is installed in the Sparkling Water Maker. Also, make sure the carbonation bottle is not connected to the Sparkling Water Maker before inserting the cylinder.
Remember, when the CO2 cylinder runs out of CO2, you can bring it back and get it exchanged for a refill. You only need to pay for the CO2 refill. It is recommended to have an extra cylinder on hand so you never run out of bubbles.
For more detailed instructions and safety warnings, please refer to pages 13 and 15-16 of the user guide provided with your SodaStream TERRA Sparkling Water Maker.
Add New Comment