Answer

Mar 04, 2025 - 12:38 AM
To configure the SALUS RX10RF Wireless Receiver Unit as a remote boiler switch, follow these steps:
1. Ensure that the unit is not powered during the configuration process.
2. Open the unit by loosening the screws at the bottom and unclipping the front.
3. Switch the internal slide switch to the RX1 position (Boiler Receiver). This is the default position.
4. Wire up the receiver according to the provided schematics for RX1 configuration.
5. Clip the front of the unit back on by aligning the fittings and pushing into place.
6. Securely xxxx the front of the receiver in place.
7. Connect the receiver to the boiler using the wireless signals it receives from other SALUS products on the SALUS Zigbee network.
Note: It is important to consult the installation guide and follow the wiring instructions specific to your system to ensure proper configuration and operation.
For more detailed instructions and illustrations, please refer to the SALUS RX10RF Wireless Receiver Unit Instruction Manual available on the SALUS Controls website at www.salus-controls.com.
Add New Comment