Answer

Mar 04, 2025 - 12:35 AM
To install the SPEKTRUM SPMXSEM0501 Firma Brushless ESC Plus 6000kv Motor 2 In 1 in your RC vehicle, follow these steps:
1. Ensure that the mounting screws are long enough to properly seat into the motor, but not too long to cause damage. The maximum depth that the mounting screws can enter into the motor is approximately 1/8 in (3mm).
2. Use the mounting hardware included with your vehicle to secure the motor in place. The vehicle's motor mounts usually feature adjustable slotted mounting holes, allowing you to adjust the gear mesh properly.
3. Ensure that the gear mesh between the pinion gear of the motor and the spur gear of the vehicle is correct and smooth with no binding. Insert a small piece of paper between the gears as you are installing them and tighten the screws that mount the system. When the mesh is at the correct distance, remove the small piece of paper by rotating the spur gear until it comes out. Check the mesh at multiple points around the larger spur gear before finalizing the motor mounting position.
4. Bundle any excess wire lengths with zip ties to keep them tidy and out of the way.
5. Connect the system's receiver lead to the throttle channel on your receiver.
6. Ensure that the system switch is in the OFF position.
7. Connect a fully charged battery to the system.
8. Always disconnect the battery from the system when you have finished operating your vehicle to prevent over-discharge.
Please refer to the complete instruction manual for additional information and safety precautions.
Add New Comment