Answer

Mar 04, 2025 - 12:25 AM
To operate the bilge pump on your SPORTSMAN 20 Island Bay Boat, you can follow these steps:
1. First, turn on the master power switch on the dash panel of your boat.
2. Locate the bilge pump switch on the switch panel.
3. Flip the bilge pump switch to the "on" position.
4. The bilge pump will start pumping out any excess water in the hull of your boat.
5. The pump is located on the hull bottom at the stern of your boat, and the water is pumped out through a thru-hull fitting located at the port stern of the boat.
6. It is important to note that the bilge pump is designed to remove excess water only and is not intended to prevent rapid accumulation of on-board water due to rough weather, hull damage, or other unsafe navigational conditions.
For more detailed instructions and safety information, please refer to the SPORTSMAN 20 Island Bay Boat Owner's Manual.
Add New Comment