User Manual Q&AAnswer
Mar 03, 2025 - 11:48 PM
To install the Bushman DC230-X fridge in a cavity, you will need to follow the instructions provided in the owner's manual. Here are the steps:
1. Ensure that you have a minimum 5mm gap on each side and the top of the fridge for ease of installation. The rear of the fridge requires a minimum gap of 25mm.
2. Refer to the recommended cut-out dimensions provided in the manual. For the DC230-X model, the cut-out cavity dimensions are 605mm width, 550mm depth, and 1460mm height.
3. Position the mounting kit flush with the front edge of the fridge cabinet and mark the position of the holes. Drill shallow, 3mm pilot holes through the sheet metal cabinet.
4. Affix the mounting kit to the side and top of the fridge cabinet using the screws provided.
5. Once the fridge has been connected to the power supply and moved into its final position, affix the mounting kit to the front of the cavity.
6. There are 4 internal mounting sleeves on the inside of the fridge cabinet and 2 internal mounting sleeves in the freezer compartment. Access is provided by gently levering off the plastic caps. Use M5 screws or bolts to secure the fridge cabinet to the mounting sleeves. Drill 4mm pilot holes through the plastic sleeve and right through the fridge cabinet sides. Put a small nylon washer onto the xxxx /bolt heads before inserting. Ensure that the exterior of the fridge cabinet is flush with your cabinetwork before affixing the screws/bolts. Check for xxxx /bolt tightness after your first trip.
7. Ventilation is crucial for the efficient operation of your fridge. You need to provide a minimum of 2 vents from the rear of the fridge cavity to the outside environment or the main room where the fridge is located. The vents should be located at the bottom and top of the fridge cavity and have a free cross-section of at least 600cm2 each.
By following these installation instructions, you can properly install the Bushman DC230-X fridge in a cavity.
Add New Comment