User Manual Q&AAnswer
Mar 03, 2025 - 11:02 PM
To install the hook assembly and collet set on the SKIL DL527501 Drill Driver, please follow the steps below:
1. Hook Assembly Installation:
a. Locate the hook assembly (Part Number: 2826568001) included in the package.
b. Align the holes on the hook assembly with the corresponding holes on the drill driver body.
c. Insert the provided screws through the holes and tighten them securely using a screwdriver or appropriate tool.
d. Ensure that the hook assembly is securely attached to the drill driver body.
2. Collet Set Installation:
a. Locate the collet set (Part Number: 3860152001) included in the package.
b. Remove any existing drill bit or accessory from the drill driver.
c. Insert the desired collet from the collet set into the chuck of the drill driver.
d. Ensure that the collet is inserted fully and securely into the chuck.
e. Tighten the chuck by turning it clockwise until it is firmly secured around the collet.
f. Verify that the collet is securely held in place and does not wobble.
Please refer to the SKIL DL527501 Drill Driver User Guide for more detailed instructions and illustrations.
Add New Comment