User Manual Q&AAnswer
Mar 03, 2025 - 10:33 PM
To connect the Menace cobLEDs to your model battery, follow these steps:
1. Connect 2, 4, 6, or 8 LEDs to the cobDriver.
2. If you are mixing different color LEDs, make sure to balance the voltage on each side of the driver. For example, red LEDs require 2V, white LEDs require 3V, and blue LEDs require 3V.
3. Connect a battery supply to the driver on the + and - pads, following the minimum voltage requirement based on the number of LEDs you are using.
Note: The cobDriver will work with the EN pad disconnected for continuous operation. If you want to have on/off control of the LEDs, you can connect the EN pad of the driver to the flight controller (FC) and follow the setup instructions for your specific flight controller. Alternatively, you can use a Menace RCswitch to connect to the EN pad if you want to control the LEDs from a radio receiver.
For more detailed instructions and information, please refer to the Menace RC LEDs Ultra Bright cobLEDs for Drones RC Planes & Cars User Manual.
Add New Comment