How do I disassemble the Lenovo G27c-30 27 Inch Monitor? (Lenovo G27c-30 27 Inch Monitor Instruction Manual)

Answer

manuals.plus

Mar 03, 2025 - 10:20 PM

To disassemble the Lenovo G27c-30 27 Inch Monitor, please follow the steps provided in the instruction manual:

1. Make sure all power connectors are removed and the monitor is powered off.
2. Prepare a soft cloth and sponge as a working platform to place the monitor horizontally.
3. Use a Phillips screwdriver (#2) to remove the four screws on the monitor.
4. Remove the stand base from the monitor.
5. Wedge your fingers between the rear cover and the middle bezel on the corners of the top side of the monitor to release the rear cover. Use gloves or a soft cloth to protect your hands.
6. Lift the rear cover carefully, disconnect the speakers' wire and joystick cable, and then remove the rear cover.
7. Tear off two pieces of conductive tape to release the wires and speakers. Remove three screws using a Phillips screwdriver (#1).
8. Remove one piece of aluminum foil, two pieces of acetate tape, and one piece of conductive tape.
9. Remove two screws using a Phillips screwdriver (#2).
10. Unplug the light bar line and LVDS line.
11. Lift up the bracket chassis and set it aside.
12. Remove all screws using a Phillips screwdriver (#2).
13. Release the middle frame from the panel.
14. Release the lamp cable from the hook and take out the mylar sheet from the main chassis.
15. Remove all screws using a Phillips screwdriver (#2).
16. Take out the PCB and peel off all mylar.
17. Take out the thermal pads from the Power PCB.

Please note that disassembling the monitor requires appropriate tools and caution. If you are not comfortable or experienced with disassembly, it is recommended to seek professional assistance to avoid any damages.