User Manual Q&AAnswer
Mar 03, 2025 - 09:17 PM
To adjust the time delay setting on your sensor switch, follow these steps:
1. Push and hold the button on the sensor switch until the LED flashes rapidly, which should take approximately 6 seconds. Then, release the button.
2. Press the button twice to enter the Time Delay adjustment mode.
3. The LED will flash back the current Time Delay setting according to the table provided in the manual. For example, if the LED flashes 5 times, it indicates a 10-minute Time Delay. Wait for approximately 3 seconds.
4. Press the button the number of times corresponding to the desired setting. For instance, if you want a 2.5-minute Time Delay, press the button twice.
5. The LED will flash back the new setting, which can be repeated up to 10 times.
6. Press the button down again until the LED flashes rapidly for approximately 6 seconds. Then, release the button.
7. Press the button twice to verify that the Time Delay has been reprogrammed.
8. The LED will flash back twice, indicating the acceptance of the new setting.
Please note that the Time Delay settings are provided in the table mentioned in the manual. You can choose the desired time increment by pushing the button the corresponding number of times.
If you have any further questions or need additional assistance, you can contact the manufacturer at the following details:
Address: 900 Northrop Road, Wallingford, CT 06492
Phone: 1.800.PASSIVE
Fax: 203.269.9621
Add New Comment