User Manual Q&AAnswer
Mar 03, 2025 - 08:41 PM
To install the TRIDONIC sceneCOM S CWM 30 BT DA2, please follow these steps:
1. Insert the device into the mounting box for the momentary switch. Ensure that the device is not connected to the mains and is supplied directly via the DALI signal line.
2. Connect the momentary switches directly to the device using potential free contacts. Do not connect the momentary switches to the mains.
3. Note that DALI signals are not SELV (Safety Extra Low Voltage). Therefore, the same procedures should be applied as when working with mains voltage.
4. Connect only one momentary switch for each device output.
5. Only one application controller is allowed in the same DALI network.
6. Avoid mounting the device behind glass, concrete surfaces, or in metal enclosures, as this can reduce the signal range. The maximum range of the Bluetooth signal is up to 20 meters.
Please refer to the TRIDONIC sceneCOM S CWM 30 BT DA2 Installation Guide for more detailed instructions and diagrams.
Note: It is important to have specialist staff carry out the installation and to observe relevant safety and accident prevention regulations. The power supply must be switched off before handling the device.
If you have any further questions or need assistance, please refer to the provided manual or contact Tridonic GmbH & Co KG directly.
Add New Comment