How do I install the Whitecroft lighting Horizon 360 LED Bulkhead Luminaire? (Whitecroft lighting Horizon 360 LED Bulkhead Luminaire Instruction Manual)

Answer

manuals.plus

Mar 03, 2025 - 07:36 PM

To install the Whitecroft lighting Horizon 360 LED Bulkhead Luminaire, follow these steps:

1. Unpack the luminaire and lay the box flat. Note that the diffuser/base moldings are not assembled.
2. Ensure that the arrows in the base molding are pointing upwards.
3. If fixing horizontally to a ceiling, the orientation is not crucial.
4. To surface mount the product, drill through the four illustrated holes on the back plate. Use these holes to mark the hole positions on the designated surface.
5. Before fixing to the surface, remove the IP44 Grommet from the fitting and pierce it from the rear. Fit the grommet, with the lead passing through, back into the cable entry hole.
6. When wiring into the product, do not place or rest anything on the LED board in a horizontal position and avoid touching the LED chips.
7. If using conduit wiring, remove the "Conduit Knock-Out" on the right side of the product. If through-wiring with conduit, remove both "Conduit Knock-Outs."
8. To through-wire the product, remove the opposite cable exit knockouts on the base. Wire out of the back of the terminal block and run the lead down the center channel of the product. Clamp at the cable exit point for cable retention.
9. When fitting the diffuser, ensure that the "short skirt" of the diffuser aligns with the "Wire way" section of the base. Ribs in the base must align with cutouts in the diffuser skirt to fully engage. Visual pips on the diffuser must align with the water-way relief cutout on the base, which should be at the bottom when the product is correctly oriented.

For further technical support or assistance, you can contact Whitecroft Lighting at Tel: 0161 331 5700 or email: technical@whitecroftlight.com. You can also visit their website at www.whitecroftlighting.com.