User Manual Q&AAnswer
Mar 03, 2025 - 07:24 PM
To change the drill bit on the , follow these steps:
1. Make sure the drill is turned off and unplugged from the power source.
2. Grasp the rear half of the keyless chuck with one hand and use your other hand to rotate the front half counterclockwise.
3. Rotate the chuck far enough so that it opens sufficiently to accept the desired accessory.
4. Insert the drill bit or other accessory about 3/4" (19 mm) into the chuck.
5. Tighten the chuck securely by holding the rear half of the chuck and rotating the front portion in the clockwise direction. You will hear a clicking sound as the chuck tightens around the accessory.
6. To release the accessory, repeat step 2 and remove the accessory from the chuck.
Please refer to the "Keyless Chuck" section in the instruction manual for visual illustrations and additional information.
Add New Comment