User Manual Q&AAnswer
Mar 03, 2025 - 03:00 AM
The tempmate M1 temperature data logger supports three start modes: manual start, start right now, and timing start. The specific start mode is defined by the parameter setting.
- Manual start: Press the left key for 4 seconds to start the logger. Please note that the command done by the button press will be accepted by the device if the display has been activated by briefly pressing the left button beforehand.
- Start right now: The logger will immediately start after it is disconnected from the computer.
- Timing start: The logger starts when the set start time is reached. Please ensure that the set start time is at least one minute.
You can configure the start mode and other parameters using the tempbase.exe software. For detailed instructions on configuring the parameters, please refer to the "Device operation instruction" section of the user manual.
Add New Comment