User Manual Q&AAnswer
Mar 03, 2025 - 02:55 AM
To install the ATDEC AD-WF-5060 Fixed Wall Mount 5060, please follow these steps:
1. Check the component checklist to ensure you have all the necessary parts for installation. Note that wall plate mounting fasteners are not supplied with the wall mount, so you will need to consult a professional installer to determine the appropriate fastener type, location, and quantity for your wall structure.
2. Gather the required tools, including a Phillips head screwdriver, power drill, suitable drill bit, driver bit for wall fasteners, stud finder, and spirit level.
3. Take note of the weight range supported by the wall mount, which is 0-50kg (0-110lb).
4. Ensure you have important information in mind before installation:
- The manufacturer accepts no responsibility for incorrect installation.
- Mounting the product incorrectly may cause serious injury or death.
- The wall mount is not suitable for outdoor use or mobile applications.
- The maximum load capacity is 50kg (110lb).
- The wall plate achieves its maximum weight rating when properly fastened to a wall with adequate structural capacity.
- A professional installer should verify the wall's structural capacity to support the total weight of all equipment being mounted.
- Exercise caution when drilling holes in walls to avoid electrical cables, water pipes, and gas pipes.
5. Mount the wall plate to the wall:
- Choose and supply appropriate wall plate fasteners.
- Ensure the wall plate is level using a spirit level or the included spirit level tool.
- On a stud wall or drywall, use a stud finder to position mounting fasteners in the center of studs.
- On a masonry wall, avoid positioning fasteners in mortar joints.
6. Attach the display brackets to the display:
- Always use multi-washers.
- Use the shortest combination of spacers, if necessary, to ensure the display is secure without forcing screws too deep.
7. Hook the display onto the wall plate:
- Angle the display and hook the display brackets over the top of the wall plate. This should be done by two people.
- The silver locking tabs on the display brackets will make a "click" sound to confirm a secure installation. Apply gentle pressure to the lower half of the display if the click does not happen automatically.
- Ensure the silver locking tabs are pushed in prior to mounting the display.
8. Check security and conceal straps:
- Gently pull the display forwards from the bottom to ensure the locking tabs have engaged with the wall plate and the display cannot be tilted upwards.
- Conceal straps behind the display using the magnets at the end of each strap to prevent accidental unlocking and dismounting.
To unlock the display from the wall plate for display removal, retrieve the straps from their concealed position and pull each strap down once briefly until a "click" is heard.
Please note that this answer is based on the provided installation guide for the ATDEC AD-WF-5060 Fixed Wall Mount 5060. For more detailed instructions and illustrations, refer to the official installation guide or contact the manufacturer directly.
Add New Comment