Answer

Mar 03, 2025 - 02:36 AM
To install the Schuller Hole 148277, 148193 Ceiling LED Lamp, please follow the steps below:
1. Before starting the installation, ensure that the electrical power is turned off at the main circuit breaker.
2. Carefully unpack the lamp and check for any visible damage. If you notice any damage, please contact the manufacturer or a qualified professional for assistance.
3. Identify the location where you want to install the lamp on the ceiling. Ensure that the ceiling can support the weight of the lamp.
4. Use the included special screws provided by Schuller for installation. These screws are specifically designed for this lamp and ensure proper stability and safety.
5. If required, mark the positions on the ceiling where the screws will be inserted. Use a measuring tape or a level to ensure accurate placement.
6. Drill pilot holes at the marked positions on the ceiling. The size of the pilot holes should match the diameter of the special screws provided.
7. Insert the special screws into the pilot holes and tighten them securely. Ensure that the screws are straight and flush with the ceiling surface.
8. Carefully connect the electrical wires of the lamp to the corresponding wires in the ceiling. Follow the color-coding or instructions provided in the lamp's manual for proper wiring.
9. Once the wiring is complete, carefully lift the lamp and align it with the installed screws. Gently slide the lamp onto the screws, ensuring a secure fit.
10. If necessary, adjust the lamp's position to align it properly with the desired lighting area.
11. Finally, turn on the electrical power at the main circuit breaker and test the lamp to ensure it is functioning correctly.
IMPORTANT: If you notice any damage to the electrical wire during installation or at any time, it is crucial to have it repaired by qualified staff to ensure safety.
Please refer to the instruction manual provided with the Schuller Hole 148277, 148193 Ceiling LED Lamp for any additional information or specific instructions related to your model.
Add New Comment