User Manual Q&AAnswer
Mar 03, 2025 - 02:32 AM
To adjust the detection range and hold time on the HYTRONIK HMW24 Flush Mount Microwave Dali Sensor, you can use the rotary switch or the remote control HRC-11. Here are the steps:
1. Using the Rotary Switch:
- Locate the rotary switch inside the sensor.
- Turn the switch to the desired channel (0-15) to select the corresponding settings.
- Refer to the table in the manual to find the specific settings for each channel, including the detection range and hold time.
2. Using the Remote Control HRC-11:
- Press the "Scene prog." button (zone 7) on the remote control to enter the programming mode.
- Use the buttons in zone 8 to set the detection range at 100%, 75%, 50%, or 10%.
- Use the buttons in zone 11 to set the hold time at 2s, 30s, 1min, 5min, 10min, 15min, 20min, or 30min.
- Press the "Memory" button to save the settings programmed in the remote control.
- Point the remote control towards the sensor unit(s) and press the "Apply" button to set the settings to each sensor unit.
Note: The remote control HRC-11 allows for more precise and customizable settings, while the rotary switch provides pre-set options.
Add New Comment