User Manual Q&AAnswer
Mar 03, 2025 - 02:25 AM
Installation and Pairing Guide for SUNRICHER SR-ZG2835RAC ZigBee xxxx Smart Dimmer:
1. Installation:
- Before installation, make sure the power is turned off.
- Follow the wiring diagram provided in the manual for either a 2-wire connection with no neutral lead or a 3-wire connection with a neutral lead.
- Ensure that the connected load is compatible with the dimmer. Refer to the user manual of the load or consult the supplier for compatibility information.
- If using LED bulbs or energy-saving compact fluorescent lamps, consider using the Bypass device to prevent flickering and glowing of the lights. The Bypass allows for proper operation of the dimmer with low loads.
- Once the wiring is complete, turn on the power.
2. Pairing with ZigBee Network:
- To pair the dimmer with your ZigBee network, you will need a ZigBee controller or hub.
- If the dimmer is already added to a ZigBee network, remove it from the network before starting the pairing process. Refer to the "Factory Reset Manually" section in the manual for instructions.
- From your ZigBee controller or hub interface, choose to add a lighting device and enter pairing mode as instructed by the controller.
- Follow the specific instructions provided by your controller or hub to initiate the pairing process.
- The dimmer should receive wireless radio signals from the ZigBee controller or hub and be added to the network.
- Once successfully paired, the dimmer can be controlled through the ZigBee network.
3. Touch Link to a ZigBee Remote:
- To pair the dimmer with a ZigBee remote, follow these steps:
- Method 1: Short press the "Reset" button on the dimmer four times (or reset the power of the device four times from the master breaker) to start Touchlink commissioning immediately. Repeat this step within the 180-second timeout period.
- Method 2: Reset the power of the device from the master breaker. Touchlink commissioning will start after 15 seconds if the dimmer is not added to a ZigBee network. Repeat this step within the 165-second timeout period. If the dimmer is already added to a network, Touchlink commissioning will start immediately within the 180-second timeout period.
- Bring the ZigBee remote or touch panel within 10cm of the dimmer.
- Set the remote or touch panel into Touchlink commissioning mode following the instructions provided in their respective manuals.
- The remote or touch panel should indicate successful linking, and the connected light will flash twice.
4. Additional Functions and Troubleshooting:
- The manual provides instructions for various additional functions such as setting minimum brightness, startup brightness, find and bind mode, learning to a ZigBee Green Power remote, and deleting learning to a ZigBee Green Power remote. Refer to the manual for detailed steps on these functions.
- If you encounter any issues or need further assistance, refer to the troubleshooting section in the manual or contact the manufacturer's customer support for help.
Note: This answer provides a general guide based on the information provided in the manual. For specific instructions and details, always refer to the product manual included with your SUNRICHER SR-ZG2835RAC ZigBee xxxx Smart Dimmer.
Source: https://manuals.plus/sunricher/sr-zg2... xxxx -smart-dimmer-manual
Add New Comment