User Manual Q&AAnswer
Mar 03, 2025 - 02:23 AM
To power up the ZUMspot RPi Elite 3.5” LCD Kit, follow these steps:
1. Make sure the SD card is installed in the Raspberry Pi 3B+.
2. Install the antenna onto the RF connector.
3. Plug in the USB micro power cable to your ZUMspot Elite 3.5” LCD kit.
4. Then plug the cable into the wall adapter and insert that into an AC outlet.
5. If the ZUMspot Elite 3.5” LCD kit doesn’t power up, press the switch on the cable and it should power up now.
Please refer to the ZUMspot RPi Elite 3.5” LCD Kit User Guide for more detailed instructions and illustrations.
Add New Comment