Answer

Mar 03, 2025 - 01:33 AM
To install the APsystems 4300805302 25A AC Connector, please follow these steps:
1. Verify the AC connector type: Check if you have the 25A AC Male Connector (EN,5-wire) or the 25A AC Female Connector (EN,5-wire).
2. Wire Stripping: Make sure you have the correct wire gauge and cable outer diameter. The wire gauge should be 5x2.5mm² (14AWG) or 4x2.5mm² (14AWG~12AWG), and the cable outer diameter should be between 10mm and 13mm. Strip the wires, ensuring that the Earth wire is longer than the Live and Neutral wires.
3. Wiring cables to the AC connectors: Set the parts on the cable in the order of 1→2→3→4. Crimp the wires according to the print on the plastic core of the connector. If you have a 4-wire cable, one of the positions can be left empty. Use a xxxx twisting torque of 0.8 + / - 0.1N.m.
4. Push Housing into the Body: Insert the Housing into the Body until you hear a click sound.
5. Insert Seal and Clamp Finger: Place the Seal and Clamp Finger into the Body, then tighten the nut using a torque of 4.0 +/ - 0.5N.m.
6. Installation of the female connector: The installation process for the cable end female connector is the same as for the male connector.
If you have any further questions or need additional assistance, you can contact APsystems at 844-666-7035 or visit their website at apsystems.com.
Add New Comment