User Manual Q&AAnswer
Mar 03, 2025 - 12:07 AM
To install the Power Bright IU Series Pure Sine Wave Inverter, please follow these steps:
1. Determine the installation position and ensure there is enough space for heat dissipation.
2. Install the inverter in a well-ventilated area, away from moist, oily, flammable, or explosive environments.
3. Connect the positive and negative battery input wires to the corresponding terminals on the inverter. Make sure the polarity is correct.
4. Connect the AC load device to the AC output terminals on the inverter. Use appropriate wiring specifications and circuit breakers based on the inverter model and rated output current.
5. Close the circuit breaker at the inverter's DC input terminal or the fuse at the battery.
6. Set the inverter's mode switch to ON to start the AC output.
7. Close the circuit breakers on the AC load line and turn on the AC load devices one by one.
8. Check the operating status of the inverter and the load. If any faults occur, refer to the Common Problems and Solutions section in the user manual for troubleshooting steps.
Please note that it is important to read the user manual carefully and comply with all safety instructions and installation precautions provided.
Add New Comment