User Manual Q&AAnswer
Mar 03, 2025 - 12:05 AM
To connect the ECOFLOW Delta Solar Panel to your portable power station for charging, you have two options: wiring the solar panels in parallel or in series.
For parallel connection:
1. Connect the positive poles of two solar panels using the MC4 parallel cable and repeat the step for the negative poles.
2. Connect the parallel cable connectors (output side) with the MC4 connectors of the Solar Charging Cable (MC4 to XT60 cable) respectively.
3. Connect the XT60 connector on the Solar Charging Cable (MC4 to XT60 cable) to the XT60 port on the portable power station to recharge the unit.
For series connection:
1. Snap the male connector of one solar panel into the female connector of the other to wire the three solar panels in series.
2. Wire the two connectors that are unwired in step 1 with the Solar Charging Cable (MC4 to XT60 cable) respectively.
3. Connect the XT60 connector on the Solar Charging Cable (MC4 to XT60 cable) to the XT60 port on the portable power station to recharge the unit.
Please note that the maximum number of panels connected in series may vary depending on the supported products. It is important to refer to the user manual of your specific portable power station for more information and methods about solar charging.
(Source: ECOFLOW Delta Solar Panel User Guide)
Add New Comment