User Manual Q&AAnswer
Mar 02, 2025 - 09:07 PM
To install the HYTRONIK HMW15 Surface Mount High Bay Dali Sensor, follow these steps:
1. Ensure that the installation is carried out by a qualified engineer in accordance with local regulations.
2. Disconnect the power supply before installing.
3. Install the sensor to a solid surface to prevent mis-triggering caused by vibrations.
4. Make sure that the environmental conditions are suitable for electronic equipment.
5. It is recommended to mount the sensors at a distance of more than 2m from each other to prevent false-triggering.
For direct junction "J" box mounting:
a. Separate the control board (A) from the facia (B) and junction box (C).
b. Make the electrical connections to the control board (A) following the detailed wiring diagram provided in the manual.
c. Secure the control board (A) to the junction box.
d. Set up the sensor modes as per sections 3 and 4 of the manual.
e. Clip the facial plate (B) to the control board (A).
For surface mount assembly:
a. Separate the control board (A) from the facia (B) and surface box (C).
b. Securely mount the surface box (C) to a flat and solid surface.
c. Make the electrical connections to the control board (A) following the detailed wiring diagram provided in the manual.
d. Set up the sensor modes as per sections 3 and 4 of the manual.
e. Secure the control board (A) to the surface box (C).
f. Clip the facial plate (B) to the control board (A).
Please refer to the manual for more detailed instructions and illustrations on the installation process.
Add New Comment