User Manual Q&AAnswer
Mar 02, 2025 - 07:05 PM
To assemble the SEALEY TP51.V2 Drill Powered Water Pump, follow these steps:
1. Remove all components from the packaging.
2. Fit the hoses to the adaptors by unscrewing the collar of the "quick release" adaptors. Insert the length of hose all the way into each adaptor and re-tighten the collar.
3. Attach both adaptors to the pump, considering the direction of flow through the pump. xxxx the spouts onto the unit, then pull back the sleeve of the adaptor and insert it onto the unit. Release the collar to secure it. To remove the adaptors, pull back the sleeve and remove the adaptor.
4. If desired, mount the pump to a surface using the supplied mounting bolt holes.
To use the SEALEY TP51.V2 Drill Powered Water Pump, follow these steps:
1. Prepare the pump and connect the adaptors.
2. Open the chuck of your electric drill to fit the shaft of the pump and secure it tightly.
3. Start the drill in a counter-clockwise direction at a minimum output of 350Watt.
4. The pump will begin to operate and pump the fluid.
5. After use, remove the adaptors, drain any remaining fluid from the unit, and store it properly.
Please note that this pump is suitable for use with an electric drill with an output of 350W or more. It can be used with water, organic solvents, motor oil, heating oil, insecticides, pesticides, liquid fertilizers, and other non-aggressive liquids. The suction head is 3m.
For further information or if you have any other questions, you can contact Sealey's technical team at technical@sealey.co.uk or call 01284 757505.
Add New Comment