Answer

Mar 02, 2025 - 10:57 AM
To attach the RYOBI A01CWG Cutting Wheel Guard to your angle grinder, please follow these steps:
1. Ensure that you have read and understood the operator's manual for your angle grinder and the instruction sheet provided with the cutting wheel guard. It is important to familiarize yourself with the safety guidelines and warnings mentioned in both manuals.
2. Wear appropriate eye protection with side shields marked to comply with ANSI Z87.1 standards to reduce the risk of injury.
3. Make sure that the cutting wheel guard and your angle grinder model (PCL445 or PBLAG01) are compatible and fit together properly before using the accessory. Do not use the cutting wheel guard if any part is damaged or missing.
4. Always attach the accessory cutting wheel guard to the wheel guard when using a Type 1 straight or cut-off wheel. Failure to use the guard insert could result in serious personal injury.
5. Attach the guard insert by following these steps:
a. Place the edge of the guard insert closest to the label over the edge of the wheel guard. The label on the guard insert should be pointing away from the cutting wheel.
b. Slide the guard insert over the grinding wheel and rotate it until the tab snaps into place.
6. To remove the guard insert, pull the tab away from the wheel guard and rotate the guard insert off of the wheel guard.
7. For detailed instructions on operating the tool, refer to the operator's manual specific to your angle grinder model (PCL445 or PBLAG01). The manual will provide instructions on grinding and cutting with the tool.
Remember, if you are not comfortable performing any of the functions described in the instructions, it is recommended to take your unit to an authorized service center for assistance.
Add New Comment