Answer

Mar 02, 2025 - 10:18 AM
To charge the RF FOBBER Key Fobs or replace the battery, please follow the instructions below:
1. Charging the Key Fobs:
- Connect the charging cable to the charging port on the Key Fob.
- Plug the other end of the charging cable into a power source, such as a USB port or a wall adapter.
- The Key Fob will start charging. The LED indicator on the Key Fob will usually turn on or blink to indicate that it is charging.
- Allow the Key Fob to charge fully before using it. The charging time may vary depending on the model and battery capacity.
2. Battery Replacement:
- If the battery in your Key Fob needs to be replaced, you will need to open the Key Fob enclosure. Please note that only qualified personnel should access the transmitter and operate the equipment.
- Disconnect all electrical power from the Key Fob before opening the enclosure.
- Carefully open the Key Fob enclosure using the appropriate tools, if necessary.
- Locate the battery inside the Key Fob. It may be secured with screws or clips.
- Remove the old battery from the Key Fob, taking note of its orientation.
- Insert the new battery into the Key Fob, ensuring it is properly aligned and secured.
- Close the Key Fob enclosure and secure it back in place.
- Reconnect the Key Fob to the power source for charging, if necessary.
Please refer to the RF FOBBER Key Fobs User Guide for specific instructions and precautions related to charging and battery replacement. It is important to follow all safety procedures and requirements outlined in the user guide to ensure safe and proper operation of the Key Fobs.
Add New Comment