User Manual Q&AAnswer
Mar 02, 2025 - 10:05 AM
To install the OCPP Automatic Paper Cutter Network Port POS Thermal Receipt Printer, follow these steps:
1. Outlook and Install Paper Roll:
- Remove the used roll paper core (if any) and insert the new roll paper. Make sure to insert it in the correct direction as shown in the illustration.
2. Connect Printer:
- Connect the printer to a power source.
- Check the indicator LED lights:
- Power Indicator: If the light is on, it means the printer is connected properly.
- Error Indicator: If the ALARM indicator twinkles, it indicates issues like lack of paper, cutter or printing head overheating.
- Paper Indicator (LED Light): Blue and red lights on mean lack of paper, no alarm means everything is working fine.
- Use the Feed Button to manually feed the paper if needed.
3. Self Test:
- Make sure the printer is connected to power but turned off.
- Press the "FEED" button and turn on the power.
- After hearing the beeper sounds, release the "FEED" button.
- A completed self-test paper will be printed, showing the printer settings and information such as firmware version, print speed, command mode, cutter and beeper enable status, network settings, code page, etc.
4. Install Driver:
- For USB port driver installation:
- Double-click "POS Printer Driver V8.11" and follow the on-screen instructions.
- Select the USB port and printer type, then click "Start Installation."
- Print a test page to verify the installation is complete.
- For WiFi driver installation:
- Double-click "Printer Test V5.1C" and follow the on-screen instructions.
- Insert the USB cable, select USB connection, and choose "Advanced."
- Set the IP of the printer WiFi to match your home network's gateway.
- Use "POS Printer Driver V8.11" to install the driver, select the network port, printer type, and IP port number.
- Print a test page to verify the installation is complete.
Please refer to the user manual for more detailed instructions and troubleshooting steps.
Add New Comment