Answer

Mar 01, 2025 - 05:45 AM
To assemble the SEALEY PBS90.V2 Industrial Hydraulic Pipe Bender with Stand, please follow these steps:
1. Ensure that you have read and understood the safety instructions in Section 1 of the instruction manual.
2. Remove the pump unit from the box and place it upside down on a smooth, flat, clean surface.
3. Attach the four 12mm socket cap mounting bolts to the lower plate (A) by aligning the mounting holes in the plate with the threaded holes in the front of the pump unit. Slide a spring washer and a plain washer onto each bolt before screwing them in.
4. Insert a tripod leg into each of the three tubular sockets located adjacent to the mounting bolts. Secure the legs in place by screwing an 8mm socket cap bolt through the side of each socket and tightening them using a 6mm hex key.
5. Carefully turn the assembly the right way up so that it is standing on its tripod legs. It is recommended to have another person assist you with this step due to the weight of the unit.
6. Place the bending rollers into suitable holes in the lower plate (A) so that they are evenly displaced on both sides of the pump unit.
7. Prepare the pivot pin (C) for insertion.
8. Lower the upper plate (B) onto the pipe bender, ensuring that the upward facing shafts of the bending rollers locate into the plate and the pivot arms are lying on either side of the front of the pump block.
9. Align the holes 'X' in the pivot arms with the hole 'Y' in the pump block and fully insert the pivot pin (C).
10. The SEALEY PBS90.V2 Industrial Hydraulic Pipe Bender with Stand is now assembled and ready for operation.
Please refer to the instruction manual for any additional information or clarification on the assembly process.
Add New Comment