Answer

Mar 01, 2025 - 05:16 AM
To install the Puig 20836N Yamaha Tracer license support, please follow the mounting instructions provided in the manual. Here is a step-by-step guide:
1. Ensure that the motorcycle is parked on a flat and stable surface.
2. Locate the license plate mounting area on your Yamaha Tracer. This is typically located at the rear of the motorcycle.
3. Remove the existing license plate holder, if applicable. This may involve unscrewing bolts or removing clips.
4. Take the Puig 20836N license support and align it with the mounting holes on the motorcycle. Ensure that it is positioned correctly and securely.
5. Insert the provided screws through the license support and into the mounting holes on the motorcycle. Tighten the screws securely, but be careful not to overtighten.
6. Double-check the installation to ensure that the license support is firmly attached and aligned properly.
7. Attach your license plate to the license support using the provided screws or any other appropriate fasteners.
8. Make sure that the license plate is securely attached and positioned correctly.
9. Test the license support by gently shaking it to ensure that it is stable and does not move excessively.
Please note that the Puig 20836N license support is verified for compatibility with the basic configuration of the Yamaha Tracer. If your motorcycle has any extra factory settings or modifications, it is recommended to consult with Puig or a professional before installation to ensure compatibility and avoid any potential issues.
For more detailed instructions and illustrations, please refer to the installation section of the Puig 20836N Yamaha Tracer instruction manual provided by www.rrdisseny.cat.
Add New Comment