How do I assemble the RELA NOW VTX100 Standing fan? (RELA NOW Standing fan User Manual)

Answer

manuals.plus

Mar 01, 2025 - 05:14 AM


To assemble the RELA NOW VTX100 Standing fan, please follow these steps:

1. Mount and connect the socket unit with the support tube. Open the case and remove the socket.
2. Assemble the tubes, with the larger tube being the bottom tube and the smaller tube connecting to the switch unit. Align the four holes in the tubes and tighten the screws. Slide on the decorative cover.
3. Place the base next to the support tube and secure the support tube to the base unit. Then tighten the outer joint.
4. Mount the propeller by connecting the protective cover and the cover ring and attaching the rear cover to the engine. Make sure to observe the direction of rotation. Lay the connection of the cover ring down and connect the deep  xxxx  of the cover ring with the circular side ring of the rear side of the unit. Then tighten the screws for the correct position of the connection with the nut.
5. Install the propeller by using the wedge  xxxx  on the back of the clamp of the propeller and connecting it to the bolt of the output shaft of the motor. Then tighten the mounting nut of the propeller in an anticlockwise direction.
6. Put the front cover together by inserting the circle of the front cover into the  xxxx  of the cover ring attached to the rear cover. Finally, tighten the  xxxx  into the ring joint.

For visual instructions, you can refer to the video tutorials provided on the manufacturer's website or scan the QR code in the user manual to watch the assembly videos.