User Manual Q&AAnswer
Mar 01, 2025 - 04:58 AM
To adjust the pitch (slope) of the awning on the RECPRO RP-PAFRM Powered Awning, follow these steps:
1. With the awning fully extended, loosen the adjustable xxxx on the adjustable pitch arm assembly.
2. Keep clear of openings around the adjustable pitch arm assembly while adjusting the awning pitch (slope). The adjustable pitch arm assembly (bottom arm) will telescope. Do not allow the corner of the entry door to contact the awning fabric.
3. Pull the top arm assembly down to lower the fabric roller tube to the desired height. While holding the top arm assembly in place, tighten the adjustable xxxx to set the pitch (slope).
4. Make sure that the top arm assembly nearest to the entry door is fully extended and that the adjustable xxxx is tightened.
5. Pull the top arm assembly farthest from the entry door down until the awning slopes about 15 degrees maximum from the other arm assembly.
6. After adjusting the angle, lock the xxxx to use the sloped awning.
Note: Do not allow water to pool or snow to accumulate on the awning fabric. Pools of precipitation can cause the awning to become unstable and could bend or collapse the assembly. When heavy rain or snow is expected, place the awning in a closed position. Lowering one arm into a water shed position (to create a slope from the other arm assembly) will allow the water to run off during a light rain.
Please refer to the RECPRO RP-PAFRM Powered Awning Installation Guide for more detailed instructions and illustrations.
Add New Comment