Answer

Mar 01, 2025 - 04:51 AM
To set up the FRIGIDAIRE EFWC505 5 Gallon Bottom Loading Hot and Cold Water Dispenser, follow these steps:
1. Place the water cooler on a horizontal surface with 10-20 cm of space behind it for ventilation.
2. If using bottles with pure water, remove the cap of the water bottle and open the water dispenser door.
3. Insert the pipe into the water bottle and ensure the cap covers the bottleneck tightly to allow water to be pumped into the water tank.
4. Push the hot water tap to generate bubbles inside the bottle, indicating that water is flowing into the hot and cold water tanks. Keep pressing the hot water tap until water flows out. No adjustment is needed for cold water.
5. Caution: Do not connect the electrical power plug until water comes out of the hot water tap.
6. After water flows out from the hot tap, you can turn on the power. The hot indicator on the front panel will light up.
7. Turn on the heating switch to start the heating system. The red indicator will be on while the heating system is working. Once the hot water reaches a temperature of 86-95°C, the red indicator will go off, indicating the heating system is on a warm-keeping status. If the hot water temperature drops below 85°C, the heating system will automatically start working again.
8. Turn on the cooling switch to start the cooling system. The green indicator on the front panel will be on. The cooling system will work when the cold water temperature falls between 5-10°C. Once the cold water reaches the desired temperature, the green indicator will go off, indicating the cooling system is on a cold-keeping status. If the cold water temperature rises above 10°C, the cooling system will automatically start working again.
9. The temperature is already adjusted before leaving the factory, so there is no need for the customer to set the temperature.
10. If you want both hot and cold water, turn on both the heating and cooling switches. The heating and cooling processes will start working simultaneously.
11. To change the water, open the door gently and pull out the water tube. Hang the water tube on the hook of the door. Remove the cap of the bottle, insert the water tube into the new bottle, and press it tightly to ensure water is pumped into the water tank. Place the bottle into the cabinet of the water dispenser.
12. The water shortage indicator light will provide information about the water level in the dispenser. Please refer to the manual for detailed instructions on the different indications of the water shortage indicator light.
13. For maintenance, disconnect the power plug before performing any cleaning. Use a water-soaked soft cloth to wipe the front and back of the product. Do not spray water directly on the surface. If the condenser accumulates dust or foreign substances, wipe it off with a water-soaked soft cloth. After cleaning, completely dry the product before connecting the power plug.
14. If you encounter any issues or need further assistance, you can contact the manufacturer's service center at 1-800-968-9853.
Please refer to the provided instruction manual for more detailed information and diagrams.
Add New Comment