Answer

Mar 01, 2025 - 04:13 AM
To connect the hose to the Splash Beach, follow these steps:
1. Locate the hose connection at the back of the Splash Beach.
2. Insert the end of the hose into the hose connection.
3. Twist the xxxx on the hose connection to tighten it closed.
4. If there is any leakage after tightening by hand, you can use a wrench to further tighten it. However, be careful not to overtighten.
Please note that the hose is not included with the product. Make sure to connect the hose before turning on the water to the desired level of spray.
Add New Comment