How do I install the Thermaltake TOUGHLIQUID 240 ARGB Sync All-In-One Liquid Cooler on an Intel or AMD system? (Thermaltake TOUGHLIQUID 240 ARGB Liquid Cooler Instruction Manual)

Answer

manuals.plus

Mar 01, 2025 - 03:37 AM

Installation of the Thermaltake TOUGHLIQUID 240 ARGB Sync All-In-One Liquid Cooler on an Intel or AMD system can be done by following the instructions provided in the manual. Here is a step-by-step guide:

1. Start by referring to the Intel or AMD Installation Guide section in the manual, depending on your system's processor.

2. For Intel installation, locate the appropriate socket type (1700/1200/1156/1155/1151/1150 or 2066/2011-3/2011) and follow the instructions provided.

3. For AMD installation, tighten the xxxx to halfway and then tighten it again to ensure the waterblock is securely installed.

4. The waterblock of the TOUGHLIQUID 240 ARGB Sync All-In-One Liquid Cooler features a rotatable LED cap. This allows you to re-orient the logo in any direction, regardless of how the cooler is installed.

5. If you wish to use the ARGB Controller, connect Cable E to the water block. This will enable you to switch between different LED modes and colors. Follow the instructions provided in the ARGB Controller Installation Guide section.

6. If you prefer to use the Motherboard RGB Software, connect Cable F to the water block. Ensure that you power off the PC before connecting the cable to the motherboard. It is important to check the positive and negative ends on the connector to avoid damaging the product.

Please note that the above instructions are a summary of the information provided in the manual. For more detailed instructions and illustrations, it is recommended to refer to the Thermaltake TOUGHLIQUID 240 ARGB Sync All-In-One Liquid Cooler Instruction Manual.