User Manual Q&AAnswer
Mar 01, 2025 - 02:01 AM
To connect RS485 sensors to your computer using the RS485/USB interface, follow these steps:
1. Connect the RS485 sensors to your computer using the RS485/USB interface cable.
2. Install the necessary driver for the RS485/USB interface on your computer. The driver installation instructions should be provided with the interface.
3. Open the RS485 software by clicking on its icon.
4. In the software, click on "Advanced Settings" located at the top right corner of the page.
5. Change the language to English if it is not already set.
6. Right-click on your computer and select "Device Manager" to open it.
7. In the Device Manager, locate the port corresponding to the RS485/USB interface. It will be labeled as "COM #" where "#" represents the port number.
8. Take note of the COM port number.
9. Go back to the RS485 software and enter the COM port number in the designated field labeled "A".
10. Click on the refresh button labeled "B" to detect the connected device.
11. Once the device is detected, click on the "C" button to establish the connection.
12. In the software, select the appropriate product name from the list by clicking on "A" and then "B".
13. Click on the "C" button to set the selected product.
14. Finally, click on the "Connecting Device" button to establish the connection with the sensor.
15. If the sensor is properly connected, you will be able to see the data status in the "Sensor Data Window" of the software.
Please refer to the itsensor RS485 Software User Guide for more detailed instructions and troubleshooting tips.
Add New Comment