User Manual Q&AAnswer
Mar 01, 2025 - 01:31 AM
To install the PQL-83441PC LED V2 Post Top Fixture, please follow these steps:
1. Ensure that you have a qualified electrician for installation. If you are unfamiliar with proper electrical wiring connections, it is recommended to seek the services of a qualified electrician.
2. Remove the trim from the box and check that no parts are missing.
3. Feed the three housing wires through one of the three rods.
4. Clip the three rods onto the housing, ensuring that the housing clips are properly engaged onto the rods.
5. Feed the fixture wires through the tenon pole adapter.
6. Slide the tenon pole adapter onto the three rods, making sure that the notches face the inside of the tenon pole adapter.
7. Tighten the three set screws at the tenon pole adapter to secure the rods.
8. Make the wiring connections with UL approved connectors and knot the wires for strain relief.
9. The tenon pole adapter can fit a tenon with a 3" or 2 3/8" diameter. Slip the tenon pole adapter over the tenon and use the appropriate length of tenon set screws (3/8" for 3" tenon, 7/8" for 2 3/8" tenon) to secure the fixture to the tenon.
10. Connect the black fixture line to the Live (L) line supply wire.
11. Connect the white fixture line to the Neutral (N) line supply wire.
12. Connect the green fixture line to the Ground (G) line supply ground.
Please note that these instructions are a general guide and it is important to consult the instruction manual for your specific model for any additional details or variations in equipment. Always disconnect power before installing or servicing the fixture.
Add New Comment