How do I install the Altronix eBridge1PCRT IP and PoE over Coax EoC Kit? (Altronix eBridge1PCRT IP and PoE over Coax EoC Kit Installation Guide)

Answer

manuals.plus

Mar 01, 2025 - 12:51 AM

To install the Altronix eBridge1PCRT IP and PoE over Coax EoC Kit, follow these steps:

1. Secure the eBridge1PCR unit to the desired mounting surface using a proper fastening device.
2. Connect a 24VAC Class 2 plug-in transformer or a 24VDC Class 2 power supply to the wire insert connector labeled "Power Input" on the eBridge1PCR unit. Use 22AWG-16AWG wire for this connection.
3. Connect a structured cable from your ethernet switch or NVR (network video server) to the RJ45 jack marked "10/100BaseT" on the eBridge1PCR unit.
4. Connect a Coax cable to the BNC connector marked "Coax" on the eBridge1PCR unit.

5. Secure the eBridge1PCT unit to the desired mounting surface using a proper fastening device.
6. Connect a structured cable from your IP camera or device to the RJ45 jack marked "10/100BaseT" on the eBridge1PCT unit.
7. Connect a Coax cable to the BNC connector marked "Coax" on the eBridge1PCT unit.

Please refer to the installation guide for more detailed instructions and illustrations.

Note: The eBridge1PCRT is designed to accommodate Megapixel, HD720, HD1080, and VGA (SD) cameras. It is important to note that some high-resolution and high frame rate cameras may require faster headend processing ability, such as a PC graphics card, to present a quality image. If the headend processing equipment is insufficient in speed, the image may show pixelation and latency. It is advisable to pre-test the system if unsure. Alternatively, frame rate and resolution may be reduced to accommodate system equipment.

For any further assistance or troubleshooting, please consult the product manual or contact Altronix customer support.