Answer

Mar 01, 2025 - 12:36 AM
To connect the Samsung SWA-9200S Wireless Rear Speaker Kits to a soundbar, please follow these steps:
1. Connect the surround speaker cables: Use the speaker cables provided to connect the two surround sound speakers. Insert the red and black colored ends of each speaker cable into the red and black jacks of the appropriate speaker. Make sure to insert the wire fully, taking care not to insert beyond the wire insulation.
2. Turn on the surround speakers: Plug the surround speakers' power cord into an electrical outlet to turn them on. The LINK LED indicator on the rear of the left surround speaker should blink quickly. If the LINK LED does not blink, please refer to the troubleshooting section in the manual.
3. Turn off the soundbar: If the soundbar is turned on, please turn it off by pressing the (Power) button on the soundbar or remote control.
4. Connect the soundbar and surround speakers: Press and hold the Up button on the remote control for more than 5 seconds until the "ID SET" message appears on the soundbar's display. After the ID SET process is successful, the soundbar will turn on automatically.
5. Check the connection: The LINK LED on the rear of the left surround speaker should stop blinking and change to solid blue when the soundbar and surround speakers are successfully linked. Turn off the soundbar and then turn it back on to confirm that the LINK LED is blue. If the LINK LED does not turn to solid blue, please refer to the troubleshooting section in the manual.
Please note that the specific steps may vary depending on your soundbar model. For more detailed information and illustrations, please refer to the user manual of your soundbar and the Samsung SWA-9200S Wireless Rear Speaker Kits.
Add New Comment