Answer

Mar 01, 2025 - 12:04 AM
To set up the ARWIN SENSO8 LoRaWAN IAQ Sensor, follow these steps:
1. Ensure that the sensor is not connected to any DC power supply.
2. Unfasten the screws and open the sensor's cover.
3. Connect the wires from the DC power supply to the terminal block on the bottom of the sensor, or insert two ER26500 Li-SOCl2 batteries into the battery compartment.
4. Put on the cover and fasten the screws on the corners.
5. If using DC supply, the LED indicator on the top cover will light up. For battery-powered models, press and hold the button on the side for 3 seconds to power on the sensor.
6. Upon power on, the sensor will send a data report. Check the server backend or dashboard to ensure that the connection has been established and data can be successfully uploaded.
Note: The sensor setup may vary depending on the specific model of the SENSO8 LoRaWAN IAQ Sensor. Please refer to the user guide for your specific model for detailed instructions.
(Source: ARWIN SENSO8 LoRaWAN IAQ Sensor User Guide)
Add New Comment