User Manual Q&AAnswer
Feb 28, 2025 - 11:58 PM
To charge the LED Solar Path Lighting RGB Puck, follow these steps:
1. If there is a thin protective film covering the solar panel, remove it before using the product.
2. Hold the solar unit firmly and turn the ground spike counterclockwise to remove it.
3. Remove the pull-tab from the battery compartment.
4. Replace the ground spike and turn it clockwise to lock it in place.
5. Place the product in a location where it can receive a full 8 hours of sunlight to allow the rechargeable battery to reach maximum capacity.
Note: It is important to place the product in an area where it can receive direct sunlight for at least 8 hours each day. Shadowed locations will not allow the battery to charge fully and may reduce the hours of nighttime lighting. Avoid placing the product near nighttime light sources such as porch lights, street lights, or pool lights, as they may cause the solar light to turn off prematurely.
Once fully charged, the product will light up for 6-8 hours.
Add New Comment