User Manual Q&AAnswer
Feb 28, 2025 - 11:51 PM
To program the 1320 International RR129-4BT remote control for your car, follow these step-by-step instructions:
1. Close and lock all doors using the driver's side power lock/unlock switch.
2. Insert the key into the ignition and remove it from the ignition key cylinder at least six times within 10 seconds. The Hazard Lamps will flash if you have performed this step successfully. Make sure to fully withdraw the key each time. If you perform this step too quickly, the system will not enter programming mode.
3. Insert the key into the ignition cylinder and turn it to the ACC position.
4. Within 5 seconds, press ANY button on the remote transmitter. The Hazard Lamps should flash. Do not press the button more than once in this step, as it may prevent the programming procedure from being successful.
5. If you have any remaining transmitters (including old ones), unlock and lock all doors using the driver's side power lock/unlock switch. Within 5 seconds, press ANY button on the next remote. The Hazard Lamps should flash. Repeat this step for each transmitter, including any existing ones.
6. Turn the key to the OFF position and remove the keys from the ignition. Unlock the doors using the driver's side power unlock/lock switch and open the driver's side door.
Please note that any changes or modifications not expressly approved by the responsible party could void the user's authority to operate the equipment. The device complies with Part 15 of the FCC Rules and must not cause harmful interference or reject any interference received.
Add New Comment