User Manual Q&AAnswer
Feb 28, 2025 - 11:20 PM
To change the batteries in the VIOTEL Accelerometer Vibration Node, you will need a T10 Torx Screwdriver and Thin Needle Nose pliers. Here are the steps to follow:
1. Ensure that the node is in Off mode.
2. Use the T10 Torx Screwdriver to remove the screws on the enclosure.
3. Carefully open the enclosure using the Thin Needle Nose pliers.
4. Locate the batteries inside the enclosure.
5. Remove the old batteries and dispose of them properly.
6. Insert new batteries into the designated slots, ensuring correct polarity.
7. Close the enclosure and secure it with the screws using the T10 Torx Screwdriver.
It is strongly recommended to power the node externally using a seven-pin male CNLinko plug when changing the batteries. The power requirements are 7.5 VDC only.
Please note that only authorized service personnel should open the inner enclosure, as there are no user serviceable parts inside. If you have any further questions or need additional support, you can contact VIOTEL's friendly staff at support@viotel.co.
Add New Comment