User Manual Q&AAnswer
Feb 28, 2025 - 11:00 PM
To install the LEONLITE PG5-1600 Series Industrial Gigabit PoE plus Managed Ethernet Switch, you can choose between DIN-Rail mounting or wall mounting. Here are the steps for each method:
DIN-Rail Mounting:
1. Use screws to install the DIN-Rail bracket on the rear side of the switch.
2. Insert the top of the DIN-Rail onto the track.
3. Lightly pull down the bracket onto the rail.
4. Check if the bracket is mounted tightly on the rail.
Wall Mounting:
1. Remove the DIN-Rail bracket from the switch by loosening the screws.
2. Place the wall mounting brackets on the top and bottom of the switch.
3. Use screws to xxxx the wall mounting brackets onto the switch.
4. Use the hook holes at the corners of the wall mounting brackets to hang the switch on the wall.
Please refer to the "Mounting Installation" section in the user manual for detailed illustrations and additional information.
Note: It is important to follow the instructions provided in the user manual to ensure proper installation and avoid any damage to the switch.
Add New Comment