User Manual Q&AAnswer
Feb 28, 2025 - 09:30 PM
Sure! Here are the step-by-step instructions for installing the Avanti WDBMC810Q3S Bottom Loading Water Dispenser:
1. Remove the exterior and interior packing from the water dispenser.
2. Place the water dispenser on a strong and level floor surface. If it is not level, adjust the front right foot until the unit is level.
3. Position the water dispenser away from direct sunlight and sources of heat.
4. Leave at least 5 inches of space between the water dispenser and the wall to allow for proper air circulation.
5. Plug the water dispenser into a properly installed and grounded wall outlet. Do not remove or cut the third (ground) prong from the power cord.
6. The water dispenser is not recommended for outdoor use.
7. Do not place the water dispenser in an area where the temperature may fall below freezing.
8. Keep the area around the water dispenser free of dust and dirt.
9. Place a full bottle of water on the floor next to the water dispenser.
10. Remove the plastic cover from the mouth of the water bottle.
11. Insert the water supply hose into the mouth of the water bottle and secure the bottle cap.
12. Slide the water bottle into the lower cabinet of the water dispenser and close the cabinet door.
13. After the water dispenser is plugged in, the motor will start pumping water into the water tanks. Wait for approximately 10 minutes for the pump to stop working.
14. Once the pump has stopped, dispense water from both the hot and cold faucets to ensure that the water is flowing properly.
15. After dispensing water, turn on the power switches for the hot and cold water systems located at the rear of the unit to begin the heating and cooling process.
16. If you do not plan to use the hot water function, you can turn off the hot water power switch to conserve energy.
Please refer to the instruction manual for more detailed information and safety precautions during installation.
Add New Comment