User Manual Q&AAnswer
Feb 28, 2025 - 08:45 PM
To connect your microphone and instrument to the AUDIBAX Roma 240 Go PA System, follow these steps:
1. Locate the Channel Input section on the PA system. This is where you will connect your microphone and instrument cables.
2. For the microphone, use an XLR cable and plug it into the XLR/6.3mm Combo input on the Channel Input section. Make sure to match the XLR connector with the XLR input.
3. For the instrument, use a TS unbalanced cable and plug it into the XLR/6.3mm Combo input on the Channel Input section. Again, match the connector with the input.
4. Adjust the volume control for each channel to set the desired level for your microphone and instrument.
5. If you want to connect another interface, such as a cell phone, guitar, or computer, you can use the RCA Left/Right inputs. Simply connect the corresponding cables to these inputs.
6. If you want to create a mono, two-loudspeaker setup, you can use the Line Output. Connect a ¼" TRS cable from the Line Output to the Channel 1 or 2 input of a second Roma 240 Go.
Note: The Line Out is a post mix, meaning it will output the mixed signal from all channels.
Please refer to the user manual for more detailed instructions and illustrations on how to connect your specific microphone and instrument to the AUDIBAX Roma 240 Go PA System.
Add New Comment