User Manual Q&AAnswer
Feb 28, 2025 - 08:08 PM
To connect your axess electronics pedals and stereo multi-FX in front of two amps with TRS switching, follow these steps:
1. Start by ensuring that you have the necessary cables for the connection. You will need two 1/4" TRS (Tip-Ring-Sleeve) cables and two 1/4" instrument cables.
2. Connect the output of your axess electronics pedals or stereo multi-FX unit to the input of the first amp using a 1/4" instrument cable. This is typically labeled as the "output" or "send" on your pedal or multi-FX unit.
3. Connect the output of the first amp to the input of the second amp using a 1/4" instrument cable. This is usually labeled as the "send" or "output" on the back of the first amp and the "input" on the second amp.
4. Now, it's time to incorporate the TRS switching. Take one of the TRS cables and connect the "send" or "output" jack of the first amp to the "tip" (T) of the TRS cable.
5. Connect the "ring" (R) of the TRS cable to the "return" or "input" jack of your axess electronics pedals or stereo multi-FX unit.
6. Finally, connect the "sleeve" (S) of the TRS cable to the "input" jack of the first amp.
7. Repeat steps 4-6 for the second amp. Connect the "send" or "output" jack of the second amp to the "tip" (T) of the second TRS cable. Connect the "ring" (R) of the second TRS cable to the "return" or "input" jack of your axess electronics pedals or stereo multi-FX unit. Connect the "sleeve" (S) of the second TRS cable to the "input" jack of the second amp.
By following these steps, you will have successfully connected your axess electronics pedals and stereo multi-FX in front of two amps using TRS switching. This setup allows you to send your signal to both amps simultaneously and control the routing using the TRS cables. Please refer to the user guide provided by AXESS ElectronicsTM for any specific instructions or additional information.
Add New Comment