User Manual Q&AAnswer
Feb 28, 2025 - 08:07 PM
To install the Stealth Products i2i Upper Torso Support System on your wheelchair, please follow these steps:
1. Mounting the i2i to Hardware:
a. Place the 17mm ball of the mounting hardware into the mounting socket in the rear of the i2i.
b. Place the split ring over the shaft behind the ball with the split section facing down.
c. Insert the four socket head screws (B) through the ring and into the threaded holes in the rear of the i2i mounting point.
d. Tighten the screws evenly with a hex key, making sure to keep the split ring parallel with the mounting socket plate on the i2i. Do not overtighten.
2. Link Hardware:
a. There are three points of angle adjustment on the link hardware. To adjust angles, lightly loosen the flat head screws, set the desired angles, and tighten the screws.
3. Flip Down Hardware:
a. To use the flip down function, use two 1/4-20 x 3/4" Socket Head Screws and four 10-32 x 3/4C Socket Head Screws for mounting to the seat back.
4. Offset Link Hardware:
a. The offset link hardware offers the same adjustability as the standard link hardware but uses 15mm square tubing and adds a posterior offset.
b. To adjust angles, lightly loosen the flat head screws triangle, set the desired angle, and tighten the screws.
Please note that these instructions provide a general overview of the installation process. For more detailed instructions and specific information, it is recommended to consult the owner's manual provided by Stealth Products or contact their customer support at (512) 715-9995 or toll-free at (800) 965-9229.
Add New Comment