User Manual Q&AAnswer
Feb 28, 2025 - 08:01 PM
To remove the bumper for installation, it is recommended to search for a specific guide on how to remove the bumper for your particular trim of the Hyundai Kona N. Once the bumper is removed, you can proceed with the installation of the VELOSSA TECH BIG MOUTH Ram Air.
Here are the steps to install the BIG MOUTH Ram Air:
1. Remove the OEM plastic flap from the radiator support. Keep the screws from the flap as you will reuse them for the installation.
2. Position the BIG MOUTH Ram Air in place, aligning it with the radiator support. Use the OEM screws to fasten the BIG MOUTH to the radiator support. Start threading the screws by hand and make sure not to over-torque them.
3. Before permanently fastening the bumper back on the car, inspect the levelness of the BIG MOUTH Ram Air. If needed, make adjustments to ensure it is properly aligned.
Please note that this answer is based on the information provided in the installation guide. It is always recommended to refer to the specific instructions provided by VELOSSA TECH for the most accurate and up-to-date installation process.
Add New Comment